Unicast Flooding Cisco Community My general question is how is it possible that the standby hsrp router gets the return path traffic and is allowed to unicast flood toward the access layer in this topology?. If l2 flows can happen such that switch doesn't see flow in both directions, switch will unicast flood. one possible solution, might be to bond to the same physical or logical switch but on different hardware ports.
Unicast Flooding Issue Cisco Community We are experiencing a lot of unicast flooding during peek time at work and i'm having a hard time finding where it comes from. here's our design : we have 8 stacks of access switches c2960x connected to our distribution 2x nexus 5k in vpc. "limited flooding is part of the normal switching process. there are situations, however, when continuous flooding can cause adverse performance effects on the network ". Unicast flooding happens when the destination mac address is not in the mac table, which could be due to stp change, removed mac entry (e.g. asymmetric routing; one way traffic), or the mac address is not installed (e.g. 1 to many mac ip mapping). One possible hardware performance issue that flooding might cause, the switch has to replicate the packet to multiple ports. depending on the switch architecture, this might cause some issues.
Solved Unicast Flooding Question Cisco Community Unicast flooding happens when the destination mac address is not in the mac table, which could be due to stp change, removed mac entry (e.g. asymmetric routing; one way traffic), or the mac address is not installed (e.g. 1 to many mac ip mapping). One possible hardware performance issue that flooding might cause, the switch has to replicate the packet to multiple ports. depending on the switch architecture, this might cause some issues. Posting i would investigate why the host doesn't respond to pings. if the l3 switch doesn't see enough frames from the host, it will time out its cam and new frames sent to that host will flood. This document discusses possible causes and implications of unicast packet flooding in switched networks. Start a conversation cisco community technology and support networking routing and sd wan any solution to solve unknown unicast flooding due to nlb clusters design. If the same vlan spans across multiple switches, the unicast flood reaches all those switches. in comparison, if the vlan is contained in one switch, the unicast flood only affects that switch. see: campus network for high availability design guide asymmetric routing and unicast flooding.
Solved Unicast Flooding Question Cisco Community Posting i would investigate why the host doesn't respond to pings. if the l3 switch doesn't see enough frames from the host, it will time out its cam and new frames sent to that host will flood. This document discusses possible causes and implications of unicast packet flooding in switched networks. Start a conversation cisco community technology and support networking routing and sd wan any solution to solve unknown unicast flooding due to nlb clusters design. If the same vlan spans across multiple switches, the unicast flood reaches all those switches. in comparison, if the vlan is contained in one switch, the unicast flood only affects that switch. see: campus network for high availability design guide asymmetric routing and unicast flooding.
Solved Unicast Flooding Question Cisco Community Start a conversation cisco community technology and support networking routing and sd wan any solution to solve unknown unicast flooding due to nlb clusters design. If the same vlan spans across multiple switches, the unicast flood reaches all those switches. in comparison, if the vlan is contained in one switch, the unicast flood only affects that switch. see: campus network for high availability design guide asymmetric routing and unicast flooding.
Solved Unicast Flooding Question Cisco Community
Comments are closed.