Solved Baseline Dimension To Virtual Sharp Intersection Point When placing the dimension, place the first point of the dimension, then select the vertical line above the fillet and immediately "right click". select intersection from the context menu, then select the horizontal line off of the fillet. inventor should snap to the virtual intersection. With the smart dimension tool already active, you right click on one of the desired entities. select “find intersection” from the menu. then click the other entity that creates the intersection. the first dimension line is now attached to that virtual sharp.
Solved Baseline Dimension To Virtual Sharp Intersection Point With the smart dimension tool active, right click on one of the edges. select “find intersection” from the drop down. next left click on the other edge. that will place a “virtual sharp” mark at the intersection of the two edges. now you can make your second selection for the dimension. In the dimension tool, right click the sketch entity or model geometry, and click find intersection. select the model geometry or sketch entity that intersects your original selection. Using virtual sharps in solidworks for dimensioning. a common method for dimensioning requires dimensioning to a point that exists where two features (e.g., edges, curves, lines, arcs, etc.) would intersect if those features were extended. Sometimes you need to place a dimension to a virtual intersection of two lines. a right mouseclick does the trick.
Solved Baseline Dimension To Virtual Sharp Intersection Point Using virtual sharps in solidworks for dimensioning. a common method for dimensioning requires dimensioning to a point that exists where two features (e.g., edges, curves, lines, arcs, etc.) would intersect if those features were extended. Sometimes you need to place a dimension to a virtual intersection of two lines. a right mouseclick does the trick. To create a virtual sharp in an open sketch, hold down the ctrl key and select two sketch entities. select the point command from the sketch toolbar in the command manager and a virtual sharp is created at the point where the sketch entities would intersect. You can place a dimension between elements using a virtual intersection point. you also can show the projection lines to the virtual intersection point, similar to that shown in the example (a virtual sharp). A common task for us is dimensioning to a point that exists where two edges, lines, arcs, and or curves would intersect if those entities were extended. this is called a "virtual sharp" in solidworks and is a useful reference in drawings and sketches.
Solved Baseline Dimension To Virtual Sharp Intersection Point To create a virtual sharp in an open sketch, hold down the ctrl key and select two sketch entities. select the point command from the sketch toolbar in the command manager and a virtual sharp is created at the point where the sketch entities would intersect. You can place a dimension between elements using a virtual intersection point. you also can show the projection lines to the virtual intersection point, similar to that shown in the example (a virtual sharp). A common task for us is dimensioning to a point that exists where two edges, lines, arcs, and or curves would intersect if those entities were extended. this is called a "virtual sharp" in solidworks and is a useful reference in drawings and sketches.
Solved Baseline Dimension To Virtual Sharp Intersection Point A common task for us is dimensioning to a point that exists where two edges, lines, arcs, and or curves would intersect if those entities were extended. this is called a "virtual sharp" in solidworks and is a useful reference in drawings and sketches.
Solved Baseline Dimension To Virtual Sharp Intersection Point
Comments are closed.