Trigger Guard Roll Pin Tool V5 In this video, mike shows you how to install a trigger guard roll pin using adjustable pliers (channel locks). this tip can save the tabs on your lower if they're not supported. I’ve always just used a block of wood and a roll pin punch set. wood doesn’t mar up anodized aluminum, so just make sure you’re not slipping with the punch. i still vastly prefer some of the newer trigger guards that eliminate roll pins entirely.
Trigger Guard Roll Pin Use a solid bench block or hard wood for support, use a coiled roll pin (split pins for the trigger guard, bolt catch and forward assist don't like the hammer and punch method), add a drop of oil to the end of the pin. We hope this article will shed a little light on the installation and prevent any catastrophes from happening while you’re assembling your trigger guard. continue reading for our step by step instructions for installing the trigger guard with detailed photos and video. In this video, i show you how i personally install the trigger guard on my ar 15 lower receiver using the roll pin punch from my bench for my build. Use the roll pin holding starter punch to start the roll pin, or hold it with needle nose pliers as you start it. it’s usually a tight fit and it’s easy to damage the end of the roll.
Trigger Guard Roll Pin In this video, i show you how i personally install the trigger guard on my ar 15 lower receiver using the roll pin punch from my bench for my build. Use the roll pin holding starter punch to start the roll pin, or hold it with needle nose pliers as you start it. it’s usually a tight fit and it’s easy to damage the end of the roll. Watch as larry potterfield explains how to install a trigger guard on an ar 15. he begins by installing the front of the trigger guard, then using a fixture for support to drive the roll pin into the rear of the trigger guard. Just install the trigger guard roll pin in a drill and use the drill at low speed to press and rotate the trigger guard pin at the same time. the ar15 trigger guard roll pin will install much easier using this method. Chad from school of the american rifle gives us the basics of ar 15 trigger guard roll pin installation and removal, and goes over some of the tools on the market that assist with the procedure of pushing in and removing roll pins, as well as how to use. This tool is specifically designed for the installation and removal of trigger guard roll pins on ar 15 lower receivers. it eliminates the need for a hammer and punch, thereby preventing potential damage to the receiver's trigger guard ears.
Comments are closed.