Sword Grip Construction Edged Weapons American Civil War Forums Today we take a look at a couple of the ways that grips on medieval swords were made, and how they functioned. this is in response to a question that was asked about an earlier post you can view here. Schematic cross sectional drawing of a one piece, two piece and four piece wooden grip. the grip, which was made of one perforated piece, with an opening that is fully filled by the tang, is not unknown in the literature.
Sword Grip Construction Edged Weapons American Civil War Forums Today we take a look at a couple of the ways that grips on medieval swords were made, and how they functioned. this is in response to a question that was asked about an earlier post you can. To state the obvious, the handle is the part of the sword that enables the user to properly wield the sword. wood was a typical cover over the blade's tang, which then could be wrapped in leather, or even wire, to prevent slippage. Note that some swords have ferrules rings of metal on each end of the grip helping to hold it in place. the hand forged sword has a leather wrapped grip with a spiral of metal wire around the top to hold the leather in place. The portion of a sword below the blade known as the hilt consists of a hand guard, handle or grip, and pommel. most medieval swords had a crossguard, but later swords became more elaborate, with the additional features of side rings, finger rings, knuckle guards, or swept hilt guards.
Medieval Sword Grip Size Arms Armor Note that some swords have ferrules rings of metal on each end of the grip helping to hold it in place. the hand forged sword has a leather wrapped grip with a spiral of metal wire around the top to hold the leather in place. The portion of a sword below the blade known as the hilt consists of a hand guard, handle or grip, and pommel. most medieval swords had a crossguard, but later swords became more elaborate, with the additional features of side rings, finger rings, knuckle guards, or swept hilt guards. The hilt (rarely called a haft or shaft) is the handle of a knife, dagger, sword, or bayonet, consisting of a guard, grip, and pommel. the guard may contain a crossguard or quillons. Swordsmith nik miller recently asked whether i had ever come across a grip construction in which the wooden core consisted solely of two chamfered strips attached to the broad faces of the tang—leaving the narrow edges uncovered. Before proceeding to a chronological description, let's have a quick look at the sword construction. the two essential parts of the medieval swords are the blade and the hilt. the prolongation of the blade which fits into the handle is the tang; the upper portion near the hilt is the ricasso. In this part of the tutorial i show you how to make the wooden grip. if you need to start at the beginning of this series of tutorials it is right here: part 1. and there are a lot of different kinds of handles you can make. i show you a plain wood handle and a wire wrapped handle.
Comments are closed.