boat traderusedboats in new england represents a topic that has garnered significant attention and interest. Boating Forum - iboats Boating Forums. Discussion of boats, general boating questions and anything else directly related to a boat or an engine. Do I need 4x4 to launch boat? - iboats Boating Forums. From another angle, if you get a locking rear end and are careful a 2wd will handle "most" ramp situations. I have seen some 2wd owners carry a set of traction mats just in case.
Additionally, it really depends on the ramp, how deep you need to launch and the surface conditions. I know of some ramps that a 2wd is fine and some where a 4wd is required. What horsepower motor to use on light weight 14' aluminum boat?. Building on this, i was wondering what size outboard motor to use on my 14' harbercraft aluminum boat?
The boat is pretty light, probably 165lb-180lb range and I bought it off a guy who used to put on top of his canopy on his truck. My boat has a 15" transom and like I said it is pretty light weight and probably... Boat taking on water | Boating Forum - iboats Boating Forums. Re: Boat taking on water Have you ran it and looked at all hoses etc? If it's not bellows, and it takes on water while on muffs, it certainly sounds like an engine cooling system issue.
This perspective suggests that, hose, manifold (s), thermostat housing, fuel cooler (not sure on 4.3) etc. From another angle, i think I'll move this to the Merc I/O section. Not sure how water entering hull on muffs could not be engine/drive related. How to use a Multimeter - iboats Boating Forums.
I thought this might be a helpful tutorial to give the members here a better understanding on how to troubleshoot their boat's electrical systems and circuits. In relation to this, multimeter Basics The Multimeter is probably the most important tool in your toolbox when you own an older boat. Over time, so much... Can I paint my boat Canvas?
Another place to check out is auto body repair shops, they have special flexible paints for repainting plastic and rubber bumpers (fenders) and other parts. How much room between boat and guide ons? My side bunks mount with 2" receivers welded to the trailer so positioning of the bunk is set by the amount you slide into the receiver. There is a bolt with a welded nut on the receiver that sets it into position.
In this context, i have a similar situation with a thru hull fitting that would hit a bottom bunk. Install drain in Aluminum boat - iboats Boating Forums. Re: Install drain in Aluminum boat Simple...go to Boaters World or West and buy the little plastic flush mount fitting and screw in plug kit....need a hole saw and a couple tiny holes and STAINLESS STEEL screws and a good wallop of sealent, slap it in, and go.
📝 Summary
Knowing about boat trader used boats in new england is essential for individuals aiming to this field. The insights shared throughout works as a valuable resource for ongoing development.