Applying Stripe Decals For placement of a stripe or decal, use the small decal location instructions (also available on this website) and or photos that come with the decal. use a cloth ruler to avoid scratching the paint, and masking tape to mark the location of the decal on the car. This is a quick look how to install vinyl body graphic rocker stripes on your car. quick and easy. just make sure area where installing is clean.
Applying Stripe Decals Learn how to properly add racing stripes and decals to your vehicle for a striking look. step by step guide with tips for applying and maintaining your designs. Learn how to apply racing stripes to your car like a professional. follow our step by step guide for perfect alignment, bubble free finish, and long lasting results. A step by step guide to ensure a correct and bubble free finish when applying graphics, stripes and decals to your car's body. To start with, we need to clean the application surface with denatured alcohol, this is the best for removing any oil residue and wax leaving a completely clean surface to apply vinyl to.
Applying Stripe Decals A step by step guide to ensure a correct and bubble free finish when applying graphics, stripes and decals to your car's body. To start with, we need to clean the application surface with denatured alcohol, this is the best for removing any oil residue and wax leaving a completely clean surface to apply vinyl to. Slide the stripes into proper position and squeegee from the center outward to each side. if you take your time, read the decal application instructions carefully and have a little patience, you can get pro results with our stripes. many of the smaller vinyl are easy enough to install by yourself. Ensure that the surface where you will be applying the vinyl graphics is clean and free of dust, dirt, and debris. use a mild cleaner if necessary, and allow the surface to dry completely before proceeding. With a squeegee, apply the stripe to the body panel working from the center of the stripe outward. as you work further down the stripe, slowly continue to remove the backing paper as needed. slowly continue to apply the stripe with the squeegee, applying even pressure across the width of the stripe. After marking where the stripes will go, spray the car with soapy water, then peel the backing off the stripe and spray the adhesive side of the stripe with the soapy water also.
Comments are closed.