Advanced Throttle Only Button Scrolller Pressing that button in disables the shift cable from being moved so you can advance the throttle in neutral. you probably don't need to use this feature with today's fuel injected outboards .just like today's cars, just turn the key and go. It does this by rotating two levers, one attached to the throttle the other attached to the shift. when you push the throttle only button it slides a shaft with a notch in it which allows a pin to move and disengage the shift lever.
All Products Throttle Only It's been a while, i deal mostly with top mounts, but i know in the classic 3000 series, that was the method to remove the throttle only button. newer gen whatevers, it's the opposite, full forward. All of the threads i have read on this have to do with the button being stuck in the throttle only position. they can not shift into gear. my problem is that i can't get it into the throttle only mode. The 'advance throttle only' allows for getting higher revs while advancing throttle without going into gear. it's used for cold starts or checking engine issues. Anyway what it is the throttle only shaft and associated parts don't return and the control handle locks up trying to go back into gear. i took the back off my control, lithium sprayed it, worked it around till it worked great. put it back together and it locked up again after i used throttle only.
Throttle Controller Ithrottle New Zealand The 'advance throttle only' allows for getting higher revs while advancing throttle without going into gear. it's used for cold starts or checking engine issues. Anyway what it is the throttle only shaft and associated parts don't return and the control handle locks up trying to go back into gear. i took the back off my control, lithium sprayed it, worked it around till it worked great. put it back together and it locked up again after i used throttle only. There is a throttle lever that when pushed forward engages the lower unit and increases the engine speed causing the boat to go faster. there is often a button on the throttle lever that will raise or lower the engine, but does not lower the idle (engine speed). Here is the best and only non destructive manner to pop out the throttle only button for a mercury classic 3000 quicksilver throttle. make sure your throttle is at 12 o'clock in the neutral position. Dual carb help! i’m working on my project virago i got running but it falls flat as soon as throttle is given. the diaphragms work just fine when bench tested but i’m worried that the lines that i. The "throttle only" button is stuck in and won't let me use only the throttle. i looked pretty stupid with my g friend driving the boat in circles while i sat on the back deck shooting powertune thru the motor.
Comments are closed.