Solved Solid Professor Practice Exercise Chegg You'll be given a few drawings with all the information needed to model intermediate and advanced parts. then, you'll be asked for a specific value or property for each of the completed part models, such as the total mass or center of gravity. Use solidworks to build the part according to the given dimensions and specifications.
Solved Practice Exercise Intermediate Advanced Part Chegg Improve your grades and reach your goals with flashcards, practice tests and expert written solutions today. Intermediate advanced part modeling. • you will have 30 minutes to answer the 3 questions in this exam. • you’re allowed to answer the questions in any order you want. • give written answers a tolerance of 0.5%, if not please re check your solid model. • reminder: save your part in a different file after each question in case it must be reviewed. You'll be given a few drawings will all the information needed to model intermediate and advanced parts. your solution’s ready to go! our expert help has broken down your problem into an easy to learn solution you can count on. You need to model a part that has 6 holes, as shown in the image on the left. you also know that you're going to have to update the part to have multiple holes, as shown in the image on the right.
Solved Practice Exercise Intermediate Advanced Part Chegg You'll be given a few drawings will all the information needed to model intermediate and advanced parts. your solution’s ready to go! our expert help has broken down your problem into an easy to learn solution you can count on. You need to model a part that has 6 holes, as shown in the image on the left. you also know that you're going to have to update the part to have multiple holes, as shown in the image on the right. Figure 3: practice exercise “basic intermediate part creation 2 (mass 5164.64 grams)” figure 4: practice exercise “basic intermediate part creation 3 (mass 5.80 pounds)” figure 5: practice exercise “intermediate advanced part creation 1 (mass 3.23 pounds view full document. Been studying for the cswa and i cannot figure this question out for the life of me! i've created a half sketch through the right plane and revolved to start. the hole features on the top aren't penetrating far enough due to the curved upper surface not being the right size a walk through of this problem would help me a ton. You’ll be given a few drawings will all the information needed to model intermediate and advanced parts. then, you’ll be asked for a specific value or property for each of the completed part models, such as the total mass or center of gravity. I'm trying to train myself using solidprofessor & i'm completly stuck on a solution to this exercise. i'm trying to mirror a rib feature and a cutout, but i'm doing something wrong.
Comments are closed.