Lab Manual 2 Rectangular And Triangular Notches Pdf Gases To investigate the discharge head characteristics of a rectangular notch and 60° triangular notches. europe witnessed a strong increase in climate variability and enhanced climate induced extreme events, such as hot drought periods, mega heat waves, and persistent flooding and flash floods. The document describes an experiment to investigate the discharge characteristics of rectangular and triangular notches. it provides the objectives, theory, assumptions, and derivation of discharge equations for both notch types.
Lab Manual 2 Rectangular And Triangular Notches Pdf Gases Experiment on flow measurement using notched weirs (rectangular & triangular). theory, equations, and discharge coefficient determination. To determine the of discharge of rectangular notch. introduction a notch is a device used for measuring the flow rate of a liquid through a small channel or tank. Two notches, rectangular and triangular, are provided with the set up. these are interchangeable and can easily be installed on the flow channel one at a time. pointer gauge is provided with the set up to measure the level of water in the flow channel and water surface elevation. it consists of a thin vertical rod, pointing at its lower end. For each measurement, calculate the experimental values of for the triangular and rectangular notches, using equations 3 and 4, respectively. record your calculations in the results tables.
Lab Manual 2 Rectangular And Triangular Notches Pdf Gases Two notches, rectangular and triangular, are provided with the set up. these are interchangeable and can easily be installed on the flow channel one at a time. pointer gauge is provided with the set up to measure the level of water in the flow channel and water surface elevation. it consists of a thin vertical rod, pointing at its lower end. For each measurement, calculate the experimental values of for the triangular and rectangular notches, using equations 3 and 4, respectively. record your calculations in the results tables. This document discusses an experimental investigation of different types of notches used to measure flow rate. triangular and rectangular notches were tested to determine which provides more accurate measurements of discharge coefficient at varying flow rates. A notches of triangular (450 & 600) and rectangular are used in this investigation and compare the results of both to find the best notch. The objective of this lab is to determine the characteristics of open channel flow over, firstly, a rectangular notch and then a triangular (vee) notch, also to determine the discharge coefficients for both notches. The discharge water is collected for 60 seconds time duration. calculate the actual and theoretical force of impact in the direction of jet. then calculate the coefficient of impact. repeat the experiment for different weights and different types of vanes.
Comments are closed.