Zen Zigbee Thermostat Heating Help The Wall I bought a zigbee wall thermostat for my bathroom underfloor heating. it joins my zigbee network but is not recognized as a climate entity in home assistant. is it possible to get this thermostat to work with zha in home assistant? paste any additional debug logs here. don't remove the extra line breaks outside the ``` marks. Temperature sensor is readable and target temperature can be set via ha. those two are problematic. they are connected. i can read the data from their sensors (temperature and batterie power). and when i change the target temperature on the device itself, it is hetting updated in ha. but i can not set the target temperature in ha.
New Tuya Round Zigbee Thermostat Drivers Devices Hubitat Pairing with phoscon works and the device is displayed in the deconz gui. device works. in the iobroker adapter i see it as a sensor named “thermostat 11”. but the device is not listed in phoscon. i use rasbee2 on rpi3 with bullseye. hi, you need to open a device request on github for this. do you have me the link please?. You can submit a device support request at the zha quirks repo asking for someone to support it, but it’s not going to be a fast process since many of the tuya devices require reverse engineering to support. Zha adds a device when pairing but no sensors or controls are loaded. unpairing pairing makes no visible difference. adding it to custom quirk doesn't work. i have the exact same issue. so far i tried this custom quirk: i added the device id at the bottom under model info in the list. Welcome to hubitat community! your thermostat uses tuya very specific communication protocol, so the generic drivers will not work. please follow the link posted above by sébastien and let us know if you need help with the installation of the custom driver.
Zigbee Thermostat Radiator Valve How Hardware Home Assistant Zha adds a device when pairing but no sensors or controls are loaded. unpairing pairing makes no visible difference. adding it to custom quirk doesn't work. i have the exact same issue. so far i tried this custom quirk: i added the device id at the bottom under model info in the list. Welcome to hubitat community! your thermostat uses tuya very specific communication protocol, so the generic drivers will not work. please follow the link posted above by sébastien and let us know if you need help with the installation of the custom driver. Have you tried checking out the issues section of zigbee2mqtt's github and see what they require to add new device support?. I wrote this driver for my zigbee thermostat whenzi x5 gc (gas boiler). it seems a beok x5h clone. its fingerprint is: manufacturer tze200 2ekuz3dz, model ts0601. when i bought that thermostat i realized that it used tuya private cluster ef00, so i installed the w35l3y’s personal tuya devices driver thanks a lot w35l3y for your work. Go to the device and then select “manage zigbee device” (click the three dots next to “reconfigure device”). the value is 10x the offset you want. the zigbee specification says an 8 bit int and the valid range is 0xe7 0x19 so 2.5 to 2.5 . Is your feature request related to a problem? please describe. hello all, i bought a zigbee air quality sensor and i achieved to add it using zha. but the sensor got no entities. for zigbee2mqtt there is a solution > koenkk zigbee herds.
Comments are closed.